Parts for Electrolux PCCI3680AFA: 03 - Main Top / Surface Units Parts

Retainer bracket that secures the main top assembly on electric cooktops. Replace if bracket is bent, broken, or missing to properly hold cooktop components.

Mounting bracket for electric cooktop installation. Secures cooktop to countertop or cabinet. Replace if bent, broken, or missing for proper support.

Secures internal components in your cooktop or oven. Replace if bracket is bent, cracked, or missing to restore proper alignment and stability.

This terminal block provides the appliance's main wiring connection point, securely joining the incoming power leads to the unit's internal wiring for reliable electrical contact. It restores a solid, safe power feed when the original connector is damaged or worn. What it does

• Holds and secures incoming power conductors to the appliance wiring harness
• Provides firm electrical contact to prevent intermittent power or arcing
• Commonly replaced for loose, melted, or burned terminals or after a short or power-fault
• Helps restore normal power delivery when appliance will not power on due to a failed connection

• One terminal block assembly

• Always disconnect house power at the breaker or unplug the appliance before servicing
• Match wire positions to the appliance wiring diagram and tighten terminals firmly
• Inspect surrounding wiring and strain relief for heat or damage; replace any compromised components

This replacement screw is a single fastener used to secure appliance panels and components. It provides a simple, durable connection for routine repairs and maintenance where the original screw has been lost or damaged. What it does:

• Secures trim, panels, brackets, or small components in place
• Restores proper fit where a missing or stripped screw causes rattling or loose parts
• Matches OEM fit when used as the specified replacement screw
• Helps maintain appliance safety and alignment when installed correctly

• Use the correct screwdriver or bit to avoid cam-out and damage
• Tighten until snug; avoid overtightening to prevent stripping or cracking
• Disconnect power before servicing if the screw secures electrical components
• Compare to the original part before installation if fit or length is critical

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

Replacement mounting screws that secure your cooktop to the countertop or cabinet. Essential when original screws are stripped, missing, or damaged during installation or service.