Parts for Frigidaire 15-092B: 03 - Wrapper Parts

A small metal mounting screw used to secure appliance panels and internal components. Simple replacement that restores proper fit and reduces rattling or loose parts when the original fastener is missing or damaged. What it does

• Secures panels, brackets, or trim pieces to the appliance chassis
• Holds internal components in place to maintain alignment and function
• Helps prevent vibration noise and movement from loose parts
• Suitable where the OEM listed screw size and thread match the original

• Disconnect power and water before servicing
• Use the correct screwdriver or driver bit to avoid stripping the head
• Start threads by hand to prevent cross-threading; tighten until snug—do not overtighten
• Keep any removed screws organized to ensure correct reassembly

This 15 x 24 A/C filter is a direct-fit replacement air filter that helps trap dust and airborne debris to protect your HVAC system and maintain proper airflow. Simple, disposable filtration for routine maintenance. What it does:

• Captures dust, lint and common household particles to reduce buildup inside the system
• Helps maintain consistent airflow by preventing large debris from clogging components
• Addresses common symptoms like increased indoor dust and reduced airflow or system strain
• Intended for regular replacement as part of scheduled HVAC maintenance

• Turn HVAC power off before accessing the filter chamber
• Insert with the airflow arrow pointing toward the air handler/furnace
• Check filter fit and seating; replace if warped or damaged
• Inspect filter monthly and replace when visibly dirty or per equipment manufacturer recommendations

This genuine panel screw secures appliance panels and trim, restoring a flush fit and stopping rattles or loose edges. Small but essential fastener for maintaining cabinet alignment and safe operation. What it does:

• Fastens panels, trim pieces, or control housings to the appliance frame
• Restores secure panel fit when a screw is missing or stripped
• Helps eliminate rattling, vibration noise, and shifted panels
• Keeps interior components covered to reduce dust and user contact risk

• Disconnect power (unplug or shut off breaker) before servicing the appliance
• Use the correct screwdriver or bit to avoid stripping the screw head
• Hand-start the screw to align threads, then tighten snugly — avoid over-torquing
• If threads are damaged, replace the mating clip or insert to ensure a secure fit

This flat washer provides a smooth, stable bearing surface for a fastener, helping distribute load and protect the mating surface. Use it when a worn or missing washer causes loose or unstable connections. What it does:

• Distributes clamping force across a wider area to prevent pull-through
• Protects finishes and reduces metal-on-metal wear under bolt heads or nuts
• Helps reduce loosening and vibration-related noise in assemblies
• Commonly used wherever a fastener needs a stable bearing surface

• Turn off and unplug the appliance before performing any repairs
• Remove surrounding panels or components as needed to access the fastener
• Replace the washer with the same size and orientation as the original
• Replace damaged or corroded fasteners with matching hardware

This hex flange nut secures components where a broader bearing surface is needed to resist loosening and distribute load. It fits 10-32 threaded studs and is used on fastened assemblies in appliances. What it does:

• Provides a secure threaded connection for 10-32 screws and studs
• Flange spreads clamping force to reduce panel or bracket damage
• Hex shape allows tightening with a wrench for a reliable hold
• Commonly replaces worn or missing nuts that cause loose panels or rattling

• One hex flange nut

• Use the correct 10-32 screw or stud and hand-start threads to avoid cross-threading
• Tighten with an appropriately sized wrench; do not overtighten to prevent thread or part damage
• Disconnect power and follow appliance safety instructions before servicing
• Replace only like-for-like; confirm size and thread match your application