Parts for Electrolux FRFG1723AV04: 04 - Cabinet Parts

This is a replacement door hinge that secures and supports a refrigerator/freezer door, restoring smooth opening and positive door closure for proper sealing and temperature control. What it does

• Replaces a worn or bent door hinge to prevent door sag and maintain correct alignment.
• Helps restore a tight door seal so the appliance can maintain proper internal temperature.
• Reduces rubbing, scraping, and uneven door movement that can cause noise or damage.
• Common symptom fix: door drops, binds, or scrolls out of alignment when opened or closed.

• One replacement door hinge.

• Safety first: unplug the appliance or disconnect power before working on the door.
• Support the door during removal and installation to prevent damage or injury.
• Use basic hand tools; keep fasteners and alignment pins organized for reassembly.
• After installation, check door alignment and gasket contact; adjust hinge mounting screws as needed.

Keeps refrigerator air fresh by reducing odors and filtering unwanted smells. Replace every 6 months for optimal performance. Verify fit with your model.

Refrigerator not cooling evenly or making unusual noise? The evaporator fan motor circulates cold air across the coil. Moderate DIY repair for most models.

This rubber grommet cushions and seals an appliance opening to protect hoses, wires, and components while reducing vibration and noise. It restores secure routing where a worn grommet allows rubbing or movement. What it does:

• Protects wires, hoses or tubing from chafing where they pass through metal or plastic openings
• Dampens vibration and helps reduce rattling or squeaking sounds
• Holds wiring or hoses in place to prevent unwanted movement or contact
• Restores a tight seal at the mounting point to keep components stable

• One replacement rubber grommet

• Disconnect power and water before starting any repair
• Access the mounting area by removing the appropriate panel or trim per your model's service instructions
• Press-fit replacement into the opening; trim or orient as required for proper fit
• If routing hoses or wiring, ensure they sit fully inside the grommet and are not pinched

Refrigerator not cooling evenly or making unusual noises? The evaporator fan blade circulates cold air throughout your fridge. DIY-friendly repair.

This outer cover protects internal components and restores the appliance's finished appearance. It keeps wiring and electronics shielded while preventing debris and accidental contact. What it does

• Shields internal components and wiring from dust, spills, and physical contact
• Helps reduce noise and vibration by securing loose openings
• Restores the appliance's exterior look where the cover was missing or damaged
• Can stop minor air leaks that affect proper airflow around controls or electronics

• Disconnect power (unplug or shut off breaker) before starting any work.
• Handle edges carefully; plastic edges can be sharp and clips/screws may be under tension.
• Save and reuse any mounting hardware shown on the appliance; replace missing fasteners with OEM-specified parts.
• After installation, restore power and verify the appliance operates and that the cover sits flush and secure.

Replacement mounting screw for refrigerator panels, brackets, and internal components. Secures parts for proper alignment and rattle-free operation.

Replacement mounting screw for refrigerator panels, brackets, and internal components. Secures parts for proper alignment and rattle-free operation.

Replacement screw for refrigerator panels, brackets, and trim. Secures components in place. Order a new fastener if original is stripped or missing.

If your refrigerator isn't cooling properly or runs constantly, the temperature sensor may have failed. This part monitors internal temps to maintain stable cooling.

Replacement mounting screw for refrigerators. Secures panels, brackets, and trim components. Replace if missing, stripped, or damaged to restore fit.