Parts for Electrolux ELTE730CAW0: 04 - Control Panel Parts

Replacement housing for washer detergent dispenser assembly. Installs in the top front panel. Order if your original housing is cracked, broken, or missing.

Seals hot and cold water connections to your washer's dispenser. Replace if you notice leaking at the inlet assembly. Confirm fit with your model number.

This water vortex valve assembly controls the flow of water to the refrigerator's dispenser and ice system, restoring normal water delivery and preventing uncontrolled flow. It replaces a worn or failed valve to help resume proper dispensing. What it does

• Opens and closes to route water to the dispenser and ice maker when activated
• Restores normal water flow if the dispenser is weak or intermittent
• Helps stop continuous or uncontrolled water flow caused by a stuck valve
• Prevents downstream leaks when the valve seats properly

• One water vortex valve assembly

• Disconnect power and shut off the water supply before starting work
• Replace the valve in the refrigerator's water line access area; use proper tools and fittings
• Inspect hoses and fittings for damage and test connections for leaks after installation

Replacement mounting screw that secures panels, brackets, and components to your washer chassis. Replaces missing, stripped, or damaged screws.

Fix detergent or fabric softener not dispensing properly with this washer dispenser cup assembly. Restores proper distribution of laundry products.

This vane screw secures the internal drum baffle (vane) to the drum, keeping loads turning properly and preventing rattles or snags. Replace a missing or stripped screw to restore a tight, stable baffle during cycles.

• Fastens the drum baffle/lifter (vane) to the rotating drum
• Helps maintain proper tumble and load turnover
• Common symptoms: loose or wobbly baffle, rattling or clunking noises, items catching on a raised baffle edge, or a baffle that detaches
• Visual cues: missing screw or stripped/damaged threads at the baffle mounting holes

• Disconnect power before servicing; shut off gas
• Access the baffle from inside the drum; align holes and start the screw by hand to avoid cross-threading
• Tighten firmly but do not overtighten to prevent stripping the drum or cracking the baffle
• Start all screws before final tightening to seat the baffle evenly

Secures hoses to pumps, tubs, and valves preventing leaks. Replace if worn, loose, or causing drips during cycles. Confirm fit with your model number.

Replaces cracked, worn, or leaking internal water hose in your washer. Restores watertight water flow between drum and dispenser components.

Secures hoses to fittings, preventing leaks in water and drain lines. Replace when connections loosen or leaks appear. Verify fit with your model number.

Fix E11 error code and washer not filling issues. This pressure sensor switch monitors water levels and signals the control board. DIY repair in under an hour.

Mounting screw for washer cabinet and component assembly. Replace if screw is stripped, missing, or damaged during disassembly. Essential hardware piece.

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

Secures wiring and hoses to your laundry center frame. Replace if cracked, broken, or missing to keep wire bundles organized and protected from wear.