Parts for Electrolux ECWM3012ASB: 04 - Lower Oven Parts

Rack assembly for electric wall ovens. Replaces cracked, bent, or missing oven racks. Installs inside the oven cavity to hold cookware during baking.

Replacement air fry tray for wall ovens. Holds food above the oven surface for even airflow and crisping. Replace if cracked, warped, or missing.

If your oven temperature is inaccurate or food cooks unevenly, the temperature probe may have failed. This sensor monitors cavity heat levels.

This door hinge secures and guides a refrigerator or freezer door, restoring proper alignment and smooth opening/closing. It replaces a worn or damaged hinge to help stop door sag, rubbing, or uneven sealing. What it does:

• Supports the door at the cabinet, bearing the door's weight and pivoting for opening/closing
• Restores correct door alignment to improve gasket contact and sealing
• Reduces door sag, binding, or scraping against cabinet or shelves
• Helps prevent uneven wear on the door and frame caused by a failing hinge

• Basic mechanical replacement; use proper tools and support the door to prevent dropping
• Power off and remove contents from the door before starting work
• Tighten mounting screws securely but avoid over-torquing to prevent damage

This replacement evaporator fan blade helps circulate cold air inside the freezer or refrigerator compartment to maintain even temperatures and proper cooling performance. A direct-fit replacement when the existing blade is cracked, warped, or missing. What it does:

• Moves air across the evaporator to promote even cooling and frost prevention
• Restores proper airflow when a damaged blade causes noise or reduced cooling
• Helps reduce hot or warm spots inside the compartment
• Quiet, balanced operation when installed correctly

• One replacement evaporator fan blade

• Disconnect power to the appliance before starting any repair
• Typically accessed by removing interior panels in the freezer/refrigerator compartment
• Inspect the fan motor shaft and mounting for damage before installing the new blade

This is a mounting nut used to secure the fan blade to the motor shaft inside a range or oven. It keeps the convection or cooling fan firmly attached so it spins properly during operation. Replace this nut if the fan wobbles, rattles, or has come loose from the motor shaft.

Hex flange nut with 10-32 thread secures components in appliances. Replace if stripped, missing, or damaged. Flange provides broader bearing surface.

This terminal block provides the appliance's main wiring connection point, securely joining the incoming power leads to the unit's internal wiring for reliable electrical contact. It restores a solid, safe power feed when the original connector is damaged or worn. What it does

• Holds and secures incoming power conductors to the appliance wiring harness
• Provides firm electrical contact to prevent intermittent power or arcing
• Commonly replaced for loose, melted, or burned terminals or after a short or power-fault
• Helps restore normal power delivery when appliance will not power on due to a failed connection

• One terminal block assembly

• Always disconnect house power at the breaker or unplug the appliance before servicing
• Match wire positions to the appliance wiring diagram and tighten terminals firmly
• Inspect surrounding wiring and strain relief for heat or damage; replace any compromised components

Replacement mounting screw for ovens and ranges. Secures panels, brackets, trim, and internal components. Replace missing or stripped screws to restore fit.