Parts for Ge CSX25GPCEWW: 04 - Shelves Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

Shelf track for refrigerator. Guides and supports adjustable shelves, allowing smooth sliding movement. Replace if cracked, broken, or worn smooth.

Upper vegetable crisper drawer pan for refrigerators. Replaces cracked, broken, or missing drawer liners. Restores produce storage in upper location.

This tempered glass shelf sits at the bottom of your refrigerator's crisper drawer to provide a clear surface for storing fruits and vegetables. It allows you to see contents below while protecting items in the drawer underneath. Replace this glass insert if it's cracked, shattered, or has chips that could contaminate food.

Slide bearing for refrigerator drawer rails. Enables smooth in-and-out drawer movement. Replace if cracked, worn, or causing drawers to stick or jam.

Left-hand drawer slide rail for refrigerator crisper or sealed pan drawers. Replace cracked, broken, or damaged rails for smooth drawer operation.

Right side drawer slide rail for refrigerator crisper and produce drawers. Replace broken, cracked, or damaged rails that no longer support smooth drawer movement.

This left-hand drawer slide assembly mounts inside the refrigerator's fresh food section. It supports the shelf/cover and guides the drawer on its track, restoring smooth operation and proper alignment when the original rail is cracked or worn.

• Mounts on the left wall to support the shelf/cover and provide a smooth sliding track for the drawer
• Keeps the drawer aligned and level for easy in-and-out movement
• Replace when the existing rail is cracked, warped, or missing tabs
• Typical symptoms: drawer hard to open/close, pops off track, shelf tilts or sags, visible damage to the rail

• Disconnect power and clear the compartment before starting
• Remove the affected drawer and its shelf/cover to access the slide
• Release locking tabs or remove mounting screws; transfer any reusable hardware to the new slide
• Test drawer travel before reloading

This is a 10-24 x 1.0 inch screw used to secure appliance panels and components. It replaces worn or missing fasteners to restore proper fit and reduce rattling or loose parts for safer, quieter operation. What it does:

• Secures panels, brackets, and trim to keep components aligned and stable
• Stops vibrating or rattling caused by loose or missing screws
• Restores proper grounding/attachment where a threaded fastener is required
• Matches OEM thread size and length for a correct fit when replacing damaged screws

• Use the correct driver bit and turn carefully to avoid stripping the head or threads
• Do not overtighten; snug until secure to prevent damage to mating parts
• Replace like-for-like with the same thread size and length for proper fit
• Disconnect power and follow appliance safety guidelines before accessing internal components