Parts for Electrolux FRFG2033AV: 06 - Cooling System Parts

This pan drain directs defrost and condensation water from the refrigerator's evaporator area into the drain pan so moisture exits safely and prevents pooling or ice buildup under the freezer or fresh-food compartments. What it does:

• Channels defrost and condensation water from the evaporator to the drain pan
• Helps prevent water pooling and ice formation inside the cabinet
• Keeps the drain path clear for proper water flow and normal defrost drainage
• Works with the refrigerator's existing drain funnel and pan system

• Basic hand tools may be required; follow manufacturer service instructions for access
• Disconnect power before servicing to avoid electrical shock
• Inspect surrounding drain trough and grommets for debris or damage while replacing
• Check connected drain tube and pan for cracks or obstructions

This sealing gasket creates an airtight seal around the appliance door to help maintain proper internal temperature and reduce energy loss. It replaces a worn or damaged door seal to restore reliable closing and consistent cooling. What it does:

• Forms a tight seal around the door edge to prevent warm air from entering and cold air from escaping
• Helps reduce frost buildup and interior condensation caused by leaks
• Can improve cooling performance and lower energy use when the original seal is compromised
• Addresses symptoms such as a door that won't fully close, visible gaps, or increased frost accumulation

• One sealing gasket

• Disconnect power to the appliance before beginning any service
• Remove the old gasket by loosening door screws or retaining trim, then press the new gasket into the channel starting from one corner
• Inspect the mounting flange and door surface for damage or debris and clean before installing
• After installation, allow gasket to form by closing the door and checking for uniform contact; warm water or a hair dryer on low can help soften the gasket for final positioning if needed