Parts for Amana ARSE66MBB / PARSE66MBB0: 06 - Façade Parts

Replace your refrigerator water filter every 6 months to ensure clean, fresh-tasting water and ice. Easy twist-on installation. Verify fit with your model.

This replacement screw secures specified refrigerator components—such as covers, brackets, and internal panels—so they stay properly mounted. Replace a missing, stripped, or corroded fastener to restore a tight, rattle-free fit and reliable operation.

• Provides the correct fastener for locations identified in your model's parts diagram
• Helps prevent looseness, vibration, and rattling of panels or brackets
• Replace if the head is stripped, threads are worn, or the screw is missing
• Symptoms can include loose parts, gaps, or noises from movement

• Unplug the refrigerator and shut off water if working near the ice maker or dispenser
• Match length and type to the original; follow your model's parts diagram for placement
• Start threads by hand to avoid cross-threading; tighten snugly without over-torquing, especially into plastic
• Keep track of screw positions; do not mix different screw lengths or styles

Color: Black

This replacement grille sump (drip tray) catches condensation and minor overflows beneath the appliance to help protect cabinets and floors from water damage. Direct-fit, black finish for a discreet repair. What it does

• Collects and channels water away from the appliance base to reduce pooling under the cabinet
• Replaces cracked, warped or missing sump that can cause visible leaks or water stains
• Restores the original drainage path so trays and drains perform as intended
• Helps stop water from contacting sensitive components under the appliance

• Disconnect power (and water if applicable) before accessing the appliance base or removing panels
• Remove the lower access panel/kickplate to access the sump; note orientation before removal
• Seat the new sump into the locating tabs/slots; ensure a snug, gap-free fit

6 - 19 x .250

Fix a dead display panel or non-responsive controls with this refrigerator control board. Common when lights go out or buttons stop working.

This limit switch monitors a set condition and opens or closes its contacts when that limit is reached. Replacing a failed switch restores proper safety cutoff and consistent operation of the appliance's heating or movement system. What it does:

• Senses a limit condition at its mounting point (such as temperature or travel/position, depending on model)
• Changes state at a defined threshold to protect components and wiring
• Interrupts power to heat or motor circuits, or signals a control to respond
• Common failure signs: no heat or shuts down early, runs continuously, won't start, or intermittent operation

• 1 limit switch

• Disconnect power to the appliance before servicing
• Note wire positions; transfer connectors one at a time or take a photo for reference
• Reinstall in the original orientation so the actuator or sensing surface contacts the correct area
• Address root causes (blocked airflow, binding mechanisms, shorted components) to prevent repeat failures