Parts for Gaggenau EB184-630: 07 - Door Parts

A replacement door fascia trim that restores the finished edge at the top or bottom of the appliance door for a clean, even appearance. Replaces a worn, cracked, or loose trim to improve fit and finish. What it does:

• Covers and protects the top or bottom door edge while maintaining the door's exterior appearance
• Helps keep the door edges sealed and aligned by replacing damaged or deformed trim
• Commonly used when trim is cracked, warped, loose, or causing cosmetic damage
• Matches OEM shape so the door closes and looks correct after replacement

• Disconnect power to the appliance before starting any repair.
• Remove the door or open it per manufacturer instructions to access trim fasteners safely.
• Keep all original screws and clips; trim typically secures with existing hardware.

This is the worktop surface that sits on top of the range body, providing the main cooking surface and housing for burners or heating elements. It serves as the structural and aesthetic top panel of the unit. Replace this part if it is cracked, chipped, warped, or otherwise damaged from heat exposure or impact.

This genuine OEM part is an oven door handle mounting bracket. The oven door handle mounting bracket secures the handle to the oven door allowing the user to open and close the oven. Over time, these brackets can loosen, causing the handle to no longer be secured to the door. If the brackets are no longer holding the handle in place, then they might need to be replaced. Luckily this is a simple repair. To replace the brackets, open the oven door and locate the screws holding the brackets in place. Remove the screws and damaged brackets. Replace the brackets with the new ones and tighten the screws to secure the handle. Make sure to test if the handle is secured tightly to the oven door. This genuine replacement part is sold individually and is compatible with Bosch, Gaggenau, and Thermador ovens.

This is a holder component that secures the oven door in place during operation. It helps maintain proper door alignment and ensures a tight seal when the door is closed. Replace this part if your oven door feels loose, does not latch properly, or fails to stay in the correct position.

This inner oven door glass replaces a cracked, broken, or fogged panel to restore safe viewing and help maintain proper heat containment in the oven. It's the interior glass panel used inside the oven door assembly. What it does:

• Replaces damaged or cracked inner door glass to restore a clear viewing window.
• Helps maintain proper heat containment and oven efficiency when installed correctly.
• Eliminates rattling or vibration caused by a loose or broken inner panel.
• Prevents debris and grease from contacting internal door components.

• Installation typically requires removing the oven door and disassembling the door outer panel; follow the appliance service manual.
• Handle glass with care and wear cut-resistant gloves and eye protection.
• Check existing clips, gaskets, and fasteners for damage and replace if needed.

Secures the glass panel to your oven door frame. Replace this clip if it's cracked, broken, or missing to properly hold the door glass in place.

This replacement frame restores the appliance's exterior trim and helps secure adjacent panels for a finished look. It returns a damaged or worn trim area to proper alignment and improves the unit's appearance. What it does:

• Replaces a cracked, warped, or missing exterior trim/frame piece
• Helps hold adjacent panels and controls in correct position
• Prevents gaps that can collect dirt or interfere with door/panel fit
• Restores the appliance's finished appearance after impact or wear

• One replacement frame piece

• Disconnect power to the appliance before starting any repair
• Remove surrounding trim or screws as needed; keep fasteners for reinstallation
• Handle carefully to avoid scratching or damaging adjacent panels