Parts for Thermador GCR484GD: 07 - Elements & Racks Parts

The Light Lens Wall Oven is an OEM part specifically designed for Bosch wall ovens. As a key component of the oven's interior lighting system, the light lens works to illuminate the baking chamber. It provides critical visibility to monitor food items during the cooking process.

Symptoms of a bad light lens can include clouding or discoloration of the plastic material reducing light transmission over time. Cracks or detachment from normal use are also causes for replacement. 

Symptoms of a failed light lens include:

• Diminished or inefficient lighting of the oven interior
• Hot or cold spots within the oven due to poor visibility 
• Possible melting or scorching of food items without consistent light

This OEM Bosch replacement part restores full illumination for effective use of the wall oven. It is also compatible with Thermador, Gaggenau, and some Kenmore wall oven models.
 

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This door seal creates a watertight barrier between the dishwasher door and tub to contain wash water and steam. Replace a worn gasket to stop drips from the door area and restore a reliable, quiet seal.

• Seals the perimeter of the door to help prevent leaks at the sides and top
• Helps the door close snugly and contain moisture/steam
• Replaces seals that are cracked, flattened, deformed, or shedding pieces
• Typical symptoms: water on the floor near the door, dampness around the door frame, visible wear, door harder to close

• Disconnect power and turn off water supply before servicing
• Pull the old seal straight out; clean the groove/channel of residue and debris
• Warm the new seal to relax it; start at the top center and press it fully into the groove, ensuring corners are evenly seated
• Close the door for several hours to help the seal set, then run a short test cycle and check for leaks

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This clean timer is the timed control used to start and advance the oven's self-clean or timed cooking functions, restoring scheduled cycle control for precise oven operation. Direct-replacement part for affected timer-controlled clean cycles. What it does

• Advances and times the oven's clean or timed cooking cycles so cycles start and end when expected
• Replaces a worn or non-responsive timer that prevents the clean cycle from starting or completing
• Helps restore manual timer-based control when electronic or faulty timers fail to advance
• Works as the mechanical/electromechanical timing control responsible for cycle sequencing

• Disconnect power to the appliance before attempting any service to avoid shock or injury
• Access may require removing the oven control panel or console; follow manufacturer instructions
• Handle the timer carefully and secure mounting screws and connectors during reassembly