Parts for Electrolux GRBN2012AF: 07 - System Parts

This support is a replacement mounting bracket that secures internal appliance components to restore proper alignment and reduce stress on surrounding parts. It's a direct-fit part used where a broken or missing bracket causes loose panels or assemblies. What it does:

• Secures internal panels, trim, or assemblies to the cabinet/frame to prevent sagging or misalignment
• Restores correct component positioning to reduce rattling, vibration, or contact noise
• Prevents extra strain on fasteners and connected parts that can lead to wear or failure
• Helps ensure proper airflow or clearance when used to support ducts, panels, or covers

• Disconnect power to the appliance before beginning any repair
• Use appropriate hand tools (screwdriver, nut driver) and retain original fasteners when possible
• Handle nearby sharp edges and insulation with care; wear gloves and eye protection
• Verify proper fit and alignment before tightening fasteners; test appliance operation after installation

This support is a small mounting bracket that secures and stabilizes appliance components for reliable alignment and reduced vibration. It helps maintain proper fit and prevents rattling or sagging of adjoining parts. What it does:

• Provides structural support and keeps panels or assemblies properly aligned
• Reduces vibration and noise caused by loose or sagging components
• Helps maintain secure attachment points for adjacent parts and fasteners
• Common symptom: loose panel, intermittent rattling, or visible misalignment

• Disconnect power and water before beginning any repair
• Installation typically requires basic hand tools; keep track of small fasteners
• Inspect surrounding parts and replace any damaged screws or clips for a secure fit

This clamp secures flexible hoses and lines to prevent leaks and maintain proper flow. It's a simple replacement part that restores a tight, reliable connection on compatible appliances. What it does:

• Holds a hose or tube firmly to a fitting or barb to stop leaks and disconnections
• Helps maintain proper water, air, or drain flow by preventing slippage
• Commonly replaced when a hose slips, vibrates loose, or shows corrosion at the clamp area
• Works wherever a band-style hose clamp is specified by the manufacturer

• Disconnect power and shut off water before starting any repair
• Loosen the old clamp and slide it off the hose, then position and tighten the replacement clamp evenly
• Use the correct screwdriver or nut driver to avoid stripping the clamp screw
• After installation, restore power/water and check the connection for leaks while the appliance runs

Fix uneven cooling or temperature fluctuations in your refrigerator with this thermostat kit. Controls cooling functions to maintain proper food storage temps.

Fixes poor cooling and warm temps caused by moisture in the sealed system. This filter-drier protects the compressor during refrigerant repairs.

Replacement mounting screw for refrigerators. Secures panels, brackets, and trim components. Replace if missing, stripped, or damaged to restore fit.