Parts for Electrolux ERFG2393ASB: 08 - Ice Maker Parts

This mounting bracket secures internal components in place to maintain proper alignment and operation. It replaces a damaged or missing bracket so panels, liners, or assemblies stay stable and reduce rattling or improper fit. What it does:

• Provides a sturdy mounting point for internal panels or assemblies
• Helps prevent movement that can cause noise, vibration, or misalignment
• Restores proper fit where a broken or missing bracket caused loose parts
• Compatible with the factory mounting locations to keep components stable

• One mounting bracket

• Handle bracket edges carefully to avoid cuts; wear gloves if needed
• Reuse original screws if undamaged; replace fasteners if stripped or corroded
• Disconnect power to the appliance before servicing any internal components

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head

Factory fastener that secures panels, brackets, and internal components. Replace missing, stripped, or corroded screws to restore tight fit and eliminate rattling.

This triple-solenoid water inlet valve controls water flow to the ice maker and water dispenser in Frigidaire and Electrolux side-by-side and French door refrigerators. If the ice maker has stopped producing ice, water is leaking from the back of the refrigerator, or the dispenser has low or no water flow, a failed water inlet valve is a common cause. The valve requires at least 20 psi of water pressure to close properly - if pressure is adequate and the valve still leaks or fails to supply water, the valve itself is likely defective and should be replaced. Disconnect water supply and unplug the refrigerator before installation. Note the positions of the color-coded water lines before removing the old valve, and confirm all push-connect fittings are fully seated with retention clips in place after installing the new one.

Secures tubes and wiring in your refrigerator. Replace if clips are broken or connections are loose. Confirm fit with your model number.

Secures refrigerator grille or trim to cabinet, preventing rattles and gaps. Replace when broken or missing to restore proper panel alignment. Verify fit with your model number before ordering.

Fix water leaks or low ice production with this refrigerator water tube assembly. Replaces cracked tubing affecting icemaker and dispenser flow. Quick repair.

Small retainer clip that secures components, panels, tubes, or wires in place inside your refrigerator. Replace when worn, broken, or missing to restore fit.