Parts for Electrolux GRFG2353AFB: 08 - Ice Maker Parts

Fix water leaks or low ice production with this refrigerator water tube assembly. Replaces cracked tubing affecting icemaker and dispenser flow. Quick repair.

This replacement refrigeration tube routes water between the dispenser/valve and internal components to restore reliable water flow and drainage. It's a simple, low-cost part that helps stop leaks and restore proper water delivery. What it does

• Channels water from the inlet valve to internal lines or dispenser components
• Replaces cracked, kinked, or clogged tubing that can cause leaks or reduced flow
• Helps stop visible drips under or inside the refrigerator when the original tube fails
• Works as a direct-fit service part when the OEM tube is damaged

• One replacement tube as shown

• Disconnect power and shut off the water supply before beginning any work
• Inspect fittings and clamps; replace any damaged fasteners to prevent leaks
• Route the tube following original path; avoid sharp bends and pinch points

Restore ice production when your refrigerator stops making ice. This freezer-mounted ice maker assembly uses a twist-eject mechanism. DIY install in 30 minutes.

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

This solenoid assembly is an electromechanical plunger actuator that restores linear motion to a linked mechanism. Replacing a failed solenoid helps return reliable actuation for latches, valves or dispenser-style components and stops intermittent or non-moving operation. What it does

• Converts electrical signals into linear movement to operate a latch, valve or dispenser actuator.
• Typical symptoms: clicking or humming without movement, intermittent operation, or complete loss of actuation.
• Restoring the solenoid can eliminate sticking mechanisms and return consistent operation.

• Disconnect power (and water, if applicable) before starting work to avoid shock or flooding.
• Remove access panels and note wiring locations; reconnect matching connectors securely.
• Handle the plunger and coil carefully; do not force into place or bend mounting tabs.
• Test operation after installation.

Secures tubes and wiring in your refrigerator. Replace if clips are broken or connections are loose. Confirm fit with your model number.

Secures refrigerator grille or trim to cabinet, preventing rattles and gaps. Replace when broken or missing to restore proper panel alignment. Verify fit with your model number before ordering.

Small retainer clip that secures components, panels, tubes, or wires in place inside your refrigerator. Replace when worn, broken, or missing to restore fit.