Parts for Thermador PRG484GGUS: 54 - Control Panel Parts

The range indicator light with lens illuminates to show when a burner or oven is active, typically located on the control panel. Replace when the light fails to turn on, stays on constantly, or if the lens is cracked or discolored.

This pilot light lens covers and diffuses the control-panel indicator lamp. Replace a cracked, missing, or discolored lens to restore clear visibility of the light, protect the lamp opening, and keep the panel looking finished.

• Covers and diffuses the indicator lamp on the control panel
• Helps protect the lamp opening from debris and accidental contact
• Restores a clean, finished appearance to the panel
• Replace if the lens is cracked, missing, loose, or discolored
• Can help when the indicator is hard to see even when lit

• Disconnect power to the appliance before servicing and allow surfaces to cool
• Access the indicator opening from the front or rear (varies by design) and remove any retainer or clips holding the old lens
• Note orientation and transfer any existing retainer or gasket if present
• Seat the new lens fully, reassemble, and test the indicator light

If your range burner won't heat properly or stays on continuously, the infinite switch may need replacement. This control regulates heat levels.

This is a door frame that surrounds and secures the oven door glass on a range or wall oven. It provides structural support and a finished appearance to the door assembly. Replace this frame if it is warped, cracked, corroded, or if the door glass has become loose or poorly seated.

This control panel is the electronic user interface that lets you select and monitor oven settings. It restores visible controls and display feedback so the range responds correctly to button presses and mode selections. What it does:

• Replaces a damaged or unresponsive front control panel/console to regain button and display function
• Enables selection of cooking modes, temperature, timers and related oven commands
• Helps resolve symptoms such as unlit or flashing display, non-responsive touch/buttons, or missing control feedback
• Interacts with internal control board and wiring; visible front surface and buttons are restored

• One control panel assembly

• Disconnect power at the appliance breaker or unplug the range before beginning work
• Handle the panel and display carefully to avoid scratching or damaging the fascia and connectors
• Verify connector seating and routing; damage to wiring or connectors may require additional parts