Parts for Lg LP1417SHR/00: Air Conditioner Parts

A replacement main electronic control that manages a laundry appliance's cycles and user interface, restoring proper operation when the original control fails. Replaces the unit that houses the control circuitry and connectors. What it does:

• Controls cycle selection, timing, and signals to motors, valves, and heaters based on user inputs and sensors
• Can resolve symptoms such as unresponsive buttons, error codes, inconsistent cycle behavior, or no cycle starts when the control is faulty
• Interfaces with the washer/dryer display and other modules to coordinate operations
• Requires correct connector hookup and secure mounting to function properly

• Disconnect power before servicing to avoid shock or damage
• Handle the assembly by its edges; avoid touching circuit components or connector pins
• Verify connector placement and secure mounting; double-check wiring harness orientation before restoring power

This power cord assembly supplies AC power to your appliance, restoring safe and reliable electrical connection when the original cord is damaged. Use it to replace frayed, cut, or non-functional power leads. What it does:

• Provides the appliance's main electrical connection to the outlet.
• Restores safe power delivery when the original cord shows wear, burning, or exposed wiring.
• Helps eliminate intermittent power loss caused by damaged or loose cord connections.
• Matches the OEM mounting and connector style for a direct fit when specified.

• One power cord assembly as shown

• Disconnect power at the breaker or unplug the appliance before attempting replacement.
• Tighten any cord clamp or strain relief per manufacturer guidance to prevent pull-out.

This display PCB assembly is the user-interface control board that runs the appliance's front-panel display and touch/selector controls, restoring visible readouts and responsive button or touchpad operation. What it does

• Receives input from the control panel and sends commands to the main control board
• Powers and drives the front-panel display so temperature, cycle status, and error codes are visible
• Replaces a board that causes a blank, flickering, or garbled display
• Restores unresponsive or intermittent touchpad/button control and incorrect panel behavior

• Disconnect power before servicing to avoid shock or damage
• Handle the PCB by the edges and avoid static discharge; use an ESD strap if available
• Verify connectors and ribbon cables are fully seated; do not force pins or tabs

This motor assembly drives the outdoor condenser fan to move air across the condenser coil so the system can release heat efficiently. Replacing a failed motor restores proper airflow and helps the outdoor unit cool reliably. What it does:

• Spins the condenser fan blade to pull air through the outdoor coil for heat rejection
• Stops overheating by restoring airflow when a motor has failed or seized
• Reduces loud grinding, buzzing or wobbling when a worn motor is replaced
• Helps resolve cooling loss caused by a fan that won't start or runs intermittently

• Disconnect all power to the outdoor unit before starting work to avoid shock
• Handle wiring carefully — match and secure the motor's connector and wire colors exactly
• Inspect the fan blade, mounting hardware and condenser for damage before completing installation
• After installation, test the system for proper operation

A complete fan assembly that moves air for proper cooling and component ventilation. Replaces a worn or failed fan to restore airflow and reduce noise from a faulty blower. What it does

• Circulates air to support evaporator/condenser heat exchange and internal ventilation.
• Helps maintain consistent temperatures by directing airflow where needed.
• Commonly linked to symptoms like reduced cooling, loud or grinding noises, or no airflow from vents.
• Prevents excessive strain on other cooling components when functioning properly.

• Disconnect power before attempting any service to avoid shock or injury.
• Handle the motor and blades carefully to avoid bending the fan or damaging the motor leads.
• Match connector type and mounting locations to the original; secure all fasteners and wiring.
• After installation, restore power and verify fan operation and proper airflow before reassembling panels.