Parts for Kitchenaid KHHS179LSS3: 04 - Air Flow Parts

The Lamp is an OEM part for Whirlpool microwaves. This lamp illuminates the interior of the microwave, allowing you to see the cooking process and monitor the condition of your food.

Causes of a bad lamp can include regular use leading to burnout, electrical issues causing the lamp to fail, or physical damage from impact or mishandling.

Symptoms of a bad lamp include:

• The microwave interior not lighting up when the door is opened or during cooking
• Flickering or dim lighting
• The lamp failing to turn on despite replacing the bulb

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Screw that secures appliance panels and components to restore proper fit and reduce movement. Use this direct-replacement fastener to swap out stripped, missing, or damaged screws that cause loose panels or rattling. What it does:

• Secures panels, trim, brackets, and internal components to maintain alignment and prevent vibration.
• Replaces stripped, corroded, bent, or missing screws that can cause rattling, gaps, or loose parts.
• Restores proper fit and function of assemblies when original fasteners fail.
• Small part — confirm size and thread match your appliance before ordering.

• Disconnect power (and water, if applicable) before starting any repair.
• Use the correct screwdriver or bit; avoid overtightening to prevent stripping or cracking.
• Replace all like fasteners in the same area if multiple are damaged to ensure even fit and alignment.

This is a genuine replacement screw used to fasten appliance panels, trim, and components. It restores secure attachment and helps eliminate rattles or loose parts for safe, reliable operation. What it does:

• Secures panels, brackets, trim pieces, or internal components
• Stops vibration-related noise caused by loose or missing fasteners
• Restores proper alignment and fit of assembled parts
• Provides the correct thread and length for the intended factory location

• One screw

• Use the correct screwdriver or bit to avoid stripping the head
• Hand-start the screw to ensure correct thread engagement before final tightening
• Tighten until snug; avoid over-tightening which can strip threads or crack plastic
• Disconnect power to the appliance before working in areas near electrical components