Stewart for Model Number SHU5315 UC/12 Do you have instructions on how to remove and replace a 00239144 wash pump?
Answer Hello Stewart. CIRCULATION PUMP / MOTOR REMOVAL:Disconnect the four wire leads, then grasp the Circulation Motor and turn clockwise a quarter turn untilthe Motor stops. Now, remove the Motor / Rear Pump Assembly from the Front PumpHousing.Note: The Front Pump Housing remains in place when the Motor is removed.With the Motor / Rear Pump Assembly removed from the unit, separate the Motor from the Rear PumpAssembly. To do so, first remove the Impeller by placing a block in the rear of the Motor and then turningthe Impeller counter-clockwise.The Rear Pump Assembly consists of four components:1. Rear Pump Housing. 3. Impeller.2. Main Pump Seal. 4. Impeller Seal.Each component can be replaced as an individual item.TO INSTALL:First, locate the Key Square on the Front Pump Housing. Next, locate the Key Square CutOut on the Rear Pump Housing.When replacing the Pump / Motor make sure to line up the Key Square with the Key Square Cut Out.Then bring the two pump halves together, and turn the Motorclockwise until it stops.Service note: The Impeller Seal Spring is compressed when the two halves of the Pump Assembly arebrought together. This will take a little force, so make sure to have a good grip on theSump as you compress the spring.Now, reattach the wiring leads, test and check for leaks. Read More... Answered by AppliancePartsPros.com | Wednesday, December 16, 2015