Gt for Model Number SHE4AP06UC/06 here it is again, this time with Model#: My Bosch dishwasher SHE 4AP06UC/06 runs for about 1 minute, you can hear the motor humming, then stops and shows CLEAN. No water. If I open the door 3 times and restart the machine after 30-40 seconds each time, then I hear the water and machine goes thru all cycles. Still does not dry the dishes. Sometimes...not always...at the end leaves dirty water on the bottom. I have to lift the flapper on the bottom of machine, hear the click and the water drains fast. There are no obstructions anywhere, hoses, filter, etc. What might be the problem?
Answer Gt, From what you are telling me the unit will run and at some point all the functions work.Fill,drain wash,etc.You must have a faulty control possibly sticking or faulty relay and when restarting your resetting the control.Part # 00701523 is your control and is located on the lower back of the base plate on the right side if your looking at the unit. Read More... Answered by AppliancePartsPros.com | Friday, August 17, 2018
Answer GT, Based on your post description we believe you have a faulty power module located in the base of the dishwasher on the right hand side. "Wash cycle abruptly ends with Clean LED glowing OR D/W runs without heating > pump starting / switching defect OR defective working relay OR (heating problem) defective heating relay > replace power module (located in base) 00701523 control. " I have to lift the flapper on the bottom of machine, hear the click and the water drains fast." By activating the "flood" switch assembly, The control activates the drain pump automatically, to clear/remove any water in the tub and keep the dishwasher from flooding the kitchen/house. Read More... Answered by AppliancePartsPros.com | Friday, August 17, 2018