Ugo for Model Number WFMC3200UC-01 Hi, Our washer doesn't control water inlet correctly. Most of the time, it will start letting water come in the drum at the beginning of the cycle, but it won't stop the water from flowing in. What we do in this case, is that we close the water valve on the wall behind for a few seconds, then we re-open it and the washer is ok. It happens on the wash and rinse part of the cycle. An appliance repairman went here and he tested the valve. He said that the valve is doing its job, that we should replace the main board, but it's almost the price of a new washer. I found one for 100$ on Ebay, replaced it but the problem is still there. What should I do? Replace the water sensor, the valve, or something else? The problem is not always 100% constant but it happens almost every time we wash. Thanks,
Answer Ugo,this sounds like a typical water valve problem. To test , once this occurs unplug the washer from power, if the water continues to flow replace the water valves, 00422244 and 00422245, if the water stops then its a control board problem. Read More... Answered by AppliancePartsPros.com | Friday, December 13, 2019