Greg for Model Number Siemens ultraSense plus Washer Model#WFX8400UC The washer starts as usual dispensing water/detergent and stops at the normal level. Then it displays "auto load adjustment" and does nothing for 2 minutes. The display then changes to "Washing" and the machine goes through the complete wash, rinse, and drain cycle but the motor does not spin at any time. Have voltage to the motor so thought it was defective and replaced it with a brand new Bosch so it's not the motor. Also checked the pressure switch tubing which is clean from the air gap to the switches.
Answer Hello Greg, You should first check that voltage is being supplied to the motor control unit 00436461. If so, you should then check to see that power is being sent to the motor assembly. If so, replace the motor assembly. If not, the motor control unit is the part at fault. I'm sorry but this part 00436461 has been discontinued by the manufacturer and no satisfactory substitutions have been provided. Thank you for your patience and understanding in this matter. Read More... Answered by AppliancePartsPros.com | Tuesday, December 13, 2022