Pete for Model Number SHP65T55UC/07 Bosch Dishwasher series 500 SHP65T55UC/07. Stops in Mid-Cycle with lights on and no code. Water is in the bottom tub, I have cleaned out the filter and there are no obstructions. Have to unplug unit and plug it back in. Restart with auto cycle. Unit lights up, water drains out properly. Then just sits there with the light on. Never goes into a wash cycle. Have unplug and plug again. One time I did get a E25 error, but the it does drain out when I power off and power on the unit. During one of these events the control panel buttons became unresponsive. I had to unplug and plug the unit to get the buttons to work again. I do run the dishwasher daily and it will run with NO problems for days. Then just go into one of these conditions. I do make sure the racks and door are all properly set. Is this a control module, door button module, or a sensor issue? Any thoughts? Thank you.
Answer Pete, if there is not a loose or damaged wire, the most likely cause of failure would be the power control module 12009532 / OEM23939958 based on the information provided. Read More... Answered by AppliancePartsPros.com | Friday, November 29, 2024