Customer Questions and Answers for Replacement Oven Control Board by Bosch

Scott, It's going to take a little more than a "novice who can handle a screwdriver." You'll most likely need the 00653424/ 00653424 Module(user interface) Remove the control panel back plate and the lower rear panel of the range and check the X2 and X3 wires and connectors between the main relay board on the back of the range and the user interface module inside the control panel. If all's OK, replace the module. Remove the knob: It is a tight fit, wrap some tape around the knob & pull gently on the ends to remove. Remove the locknut Remove upper rear access panel, remove connector from board, remove the 6 screws holding the board. Reassemble new board in reverse order after checking the board configuration.(click on the AP number inside the brackets [ ] the system will automatically take you to the parts order screen with the cost of the part, etc.you can also process the part(s) order from the same screen. Thanks,