Ken I have a bosch Nexxt 300 series that is not getting enough water out of the clothes on spin. If I wash a smaller load it seem to be ok. I've blown all the crud out of my water lines and the tub spins true and I don't hear any bearing grinding. Is it possible my motor is just worn out or am I missing something else? Motor part 00660487.
Answer Hello Ken,since you did not mention the control showing a fault alert the control board doesn't see a problem. With washers with electronic controls, the control board through the motor control board sends power to drive the motor, it also can sense basket rpm and out of balance feedback. If the washer spins ok with no or small loads but cannot seem to reach full speed with a mid to full load, the control is sensing what it thinks is a heavy waterlogged or out of balance load and will try to reach as high a speed as it can without overloading the motor or cause excessive shaking. This is usually traced to a rear spin bearing or basket spider problem which may be showing only as the washer starts to go into the spin cycle at a certain rpm range. Read More... Answered by AppliancePartsPros.com | Wednesday, April 22, 2020