Peter G. for Model Number Rdds 30v The ignitors spark but burners do not light. Sometimes all burners spark out of control at once and won't stop when one burner is lit. LH burners with simmer control seem to be more problematic not starting, lack of gas. What parts should I be looking at? I have spare non-simmer valves off another stove. Can I install those and un-install the simmer control?
Answer Hello Peter, You cannot re-design the appliance by installing parts not called for on your unit. This could cause a hazardous condition. When the unit sparks after the flame is lit it indicates a loss of chassis ground to the burner areas. You will need to do some disassembly and sand and/or clean up the areas around where the panels are held together with screws. This will re-establish ground to the burner areas so the simmer control can properly detect the flame. Since this is done by the simmer control reading the resistance of the flame, the ground to the ignitor/burner base is very important. Read More... Answered by AppliancePartsPros.com | Tuesday, September 22, 2015