Mike for Model Number Thermador PODC302J/05 Hi, l have a Thermador PODC302J/05. Yesterday we had a power outage. I saw that we had a low voltage to the home as some lights were on but very dim. l shut off the power to the home until full voltage was restored a couple hours later. The oven was not turned on during the low voltage state (but had power supplied it). Later I tried using the oven, when setting it to bake there was a delay of about 5 seconds before it would turn on. Usually it's instant. Some of the modes would not work. I tried resetting it by turning off the breaker for 5 minutes, no difference. When I switch to a mode that won't work the blue power light will blink steadily. If I then turn on the bottom oven more of the modes on the top won’t work. The same happens to the bottom oven. With both ovens on, more modes on both ovens won't work. I get the flashing light for either if I switch to a mode that won’t work. No error code on the screen not sure if this model will show codes. At times all modes will work on one oven but if I turn on the other oven some modes will not work again. Just tried the top oven and everything worked. Speed convection will not work on both ovens at the same time. If I set one to speed convection it will work, but the other one will not. I get the Flashing blue power light. This happens to both ovens. It will work on one oven at a time, but not together. The power supply #00663802. Do you have the output specs so I can check it? It seems either the power supply to the control module #12022214 or the control module itself. It Seems to not be able to run both at the same time. I used both ovens a couple of days ago with no problems. It's been installed 6 years with not a lot of use. Thanks
Answer Mike, Based on what is happening, this would most likely be an issue with the control module on the unit. Read More... Answered by AppliancePartsPros.com | Monday, September 18, 2023