Chris for Model Number SHP865ZD6N/01 As a landlord I have learned on your site that when a dishwasher isn't filling enough its usually a problem with the fill valve / relay or an obstruction in the water line. So when my Bosch SHP865ZD6N/01 wasn't cleaning well, wasn't dissolving the soap tab, and had a water level below the screen I ordered a new fill valve (in transit). But the Q&A here seems to indicate that the fill valve likely isn't at fault. Can you tell me (us) if Bosch is different and these don't fail in the same way? Or rarely fail? In another Q&A you said it might be the control board - is that the likely solution if not an obstruction? Thanks for everything!
Answer Chris, the water inlet valve 10023852 should allow 1/2 gallon of water to pass through for every minute that it is activated. If the valve is producing 1/2 gallon of water after 1 minute (the control may stop filling briefly, then start again) then the failure would likely be in the control module 12026970. If the valve does not allow the proper amount of water to pass through within a collective 1 minute of operation, it has failed and would need to be replaced. Read More... Answered by AppliancePartsPros.com | Monday, April 5, 2021