Customer Questions and Answers for Range Oven Electronic Clock Timer Control Board by Frigidaire

Hello Robert. The F10 indicates that the electronic oven control board senses a runaway temperature condition in the oven through the oven sensor circuit. This can be caused by a faulty oven temperature sensor probe or a failed electronic control board. Oven temperature is detected by the control board as it monitors the resistance through the oven temperature sensor circuit. You could have a failed oven temperature sensor, a wiring harness failure, an open thermal switch or a failed electronic oven control board that would cause this problem. The first component to check would normally be the oven temperature sensor probe. If you have a volt/ohm meter, you can shut off the breaker for the range and remove the screws that mount this sensor to the back wall of the oven. Carefully pull the wire harness into the oven cavity until you get to the wire harness disconnect plug. You should have enough slack to pull it this far into the oven. Disconnect the sensor but do not let the wire harness retract back through the back wall of the oven or it will be hard to reconnect. Measure the resistance of the oven temperature sensor with your volt/ohm meter. At room temperature, the resistance should measure around 1100 ohms. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html