George for Model Number plef489cca Hi. This is George again!!(see second question in this section). I replaced the switch as well as the dual left front burner which was burned out. I still have no heat on the left front or bridge. I have a good diagram and studied it carefully. After checking the orange wire at the burner element I find it to be getting 120V even with the knob in the off position. I checked at the switch and the same is true as the voltage is reading 120V from the L2 (red wire Top of switch) going to the orange also the yellow wire(4 and 4A). It is a new switch and I assume it to be defective. All the elements are good in that they have readings similar to the elements that work on the original assembly. I feel I am wired correctly....Keep in mind the element ceramic 4 pole connector is turned backwards from the factory elements I removed. What is in those ceramic elements? Could there be a problem in there ? Or is the switch defective? Thanks again. George
Answer Hi George. Did you find and use the wiring diagram supplied with the unit as discussed ? PLease send me your complete email so we can discuss this further. Thank You. Read More... Answered by AppliancePartsPros.com | Wednesday, April 4, 2012