Customer Questions and Answers for Module Control Asm by Ge

Jerry, You may not need a module at all. First thing to check is the amount of water in tne bottom of the tub. Start the dishwasher and allow to run for five(5) minutes, then unlatch and open the door, remove the lower rack and check the water temperature(120 dgrs. minimum) and water level " Amount of Water – Make sure dishwasher is level. Check water level, allowing dishwasher to fi ll normally for fi rst fi ll. The water level should be to the center of the bottom of the fl oat dome. If water level is low, check for clogged screen in water valve and check float switch." Low water level and or low water temp. can give the impression of not operating properly. Allow the dishwasher to run the complete cycle and make sure the dishwasher fills and drains properly and the drain system is not syphoning the water out of the tub during the cycle.