Siming for Model Number GE ZBD3500ZZ1WW When I put my washer in Rinse&Hold mode, it can drain all the water when it's done. So the water pump and drain solenoid should all be working. But when it is in full washing cycle mode, it goes through all stages just fine. But at the end, it leave a full tank of clean water in the washer. I have replaced Sequence Switch (AP2039701). But the same problem still exists. Any more ideas? Thanks much.
Answer Hello Siming. Based on the information, it sounds like the control board assembly WD21X10116 is bad and will need to be replaced. Hope this helps. Read More... Answered by AppliancePartsPros.com | Monday, January 9, 2012