Jayson for Model Number WT4870CW I had an OE code on my display and the washer could not complete cycles. I checked the pump for blockages and did a reset. The washer worked for almost a full cycle but then at the end when going through the final spin cycles the pump started to glitch. It would turn on for a second, the display flashes and glitches and the pump turns off. All in about a second.. then the washer starts over on that part of the cycle and does this again until it gets either an OE or a uE.. I replaced the pump and it still does the same thing. Could this be a control board/mother board issue? It looks like it’s about $300 and I’m trying not to throw parts at it chasing an issue if I can avoid that. Thank you for your advice.
Answer Jayson,This indicates a drainage issue, check the pump and the inner and outer drain hoses for clogs. Check the machine for a build-up causing excess suds. Run a washer cleaner through the machine (such as Affresh). If everything is clear and clean and this continues, you may have to replace the board. Read More... Answered by AppliancePartsPros.com | Tuesday, October 15, 2024