Marqus for Model Number WTW8900BW0 Good morning while hooking up my whirlpool cabrio platinum and started a normal washing cycle. I noticed mid way through the wash it jumped down from 27 minutes to 4 minutes. Drained the remaining water in the drum than did a few spins than shut off and gave me a OL code. I have done some research and everything I have seeing so far stated to replace the motor stator. I have taken apart and cleaned the agitator, also have purchased a new motor stator and replaced. Since than I am still recieveing the OL code with 4 pieces of towels in the washer. What else could be the problem that I am missing?
Answer Hello Marqus, the fault code refers to the control board showing the drive motor requiring too much power in wash.In that case, the control board will cancel the cycle. On this washer design for that code, first, remove the clothes basket and check the drive shaft for corrosion, the basket has to float up about an inch in the wash cycle to disengage the hubdrive gear, also that there is no clothing that got under it as it would cause the same problem. Read More... Answered by AppliancePartsPros.com | Friday, November 6, 2020