Michael for Model Number Kenmore Elite 79631512210 My washer shows no error codes but does not fill with water. When I start the cycle, It makes a few clicks, and then starts to agitate the clothes, as if the washer has water in it. I have continuity to all the solenoids, I've replaced the pressure switch, swapped the mainboard, and still had the same results. It will fill, spin, and drain in test mode, and the display shows a change in pressure as the barrel fills up. There was some water/lint contacting the overflow sensor EBD50360202, but there was no change after cleaning it. I also tried it with the overflow sensor disconnected but got the same result. I get no continuity through the overflow sensor. Any ideas?
Answer Hello Michael, This is most likely a programming issue in the Main PCB Assembly EBR75639504 since it can be forced to operate in the test mode but will not go through the program correctly. Read More... Answered by AppliancePartsPros.com | Tuesday, July 6, 2021