Jason for Model Number RFG297AABP/XAA I replaced the ice maker after previous ice maker was making but not releasing ice cubes. I assumed that this was a bad defrost circuit in the ice maker. After replacement, the new ice maker produces no ice at all. I have reset and reinstalled the icemaker. I checked the water inlet valve. The water dispenser works with good pressure. The water inlet valve has 1 input with 2 outputs. Water dispenser output working but not sure how to force ice maker side to try to output. Appears that ice maker is not receiving water, but unsure what to check next.
Answer Jason, On the icemaker there is a button that you would push and hold for 10 seconds that should allow the icemaker to cycle and then you can test to see if there is 120 vac to it and if there is then this will be a bad water valve. Read More... Answered by AppliancePartsPros.com | Monday, February 26, 2018
Answer Jason, You may want to remove the panel and recheck the wiring connections. Then press and hold the "test" button for 2 or 3 seconds (test button is in the upper right hand corner of the front of the ice maker) the ice maker should start to run and rotate, if not, you'll need to check the main control board for damage or dark burnt spots, and power out to the ice maker. Of course, if the ice maker advances and completes the test cycle, but theres no fill, then the water valve would be at fault and need to be replaced. Read More... Answered by AppliancePartsPros.com | Monday, February 26, 2018