Mark for Model Number 81362130 I have a Kenmore 60 Series top loading washer..I noticed the clothes are not getting cleaned. After the rinse cycle soap remains some soap remains on the clothes. (I use liquid soap). I noticed the agitator is only moving a little bit (about an inch back and forth)during the wash and spin cycle. I watched your video suggesting the agitator bolt might need replacement. How do I know if the agitator bolt is the problem? If I remove the bolt is there something I can inspect to confirm the bolt needs replacement ? The spin cycle seems to work just fine. The tag with the model number (affixed to the lip of the tub) has the following groups numbers on it. Not sure which one is the model number. 81362130 3621 9.8 60 120 C500506224
Answer Mark, the agitator bolt would only need to be replaced if it has broken off and is allowing the agitator to lift up off of the drive shaft. As the spin cycle is operating properly, it would be recommended that the agitator bolt and agitator are removed so that the teeth at the bottom of the agitator can be inspected. If there is no damage to the teeth of the agitator, the most likely cause of failure would be the transmission 389245 if the motor operates properly during the agitation cycle. Unfortunately, the transmission has been discontinued by the manufacturer and is no longer available. Read More... Answered by AppliancePartsPros.com | Wednesday, April 24, 2024