Sherri Hall for Model Number WTW4950XW2 Hi. I have a Whirlpool Washer. When I run the automatic Test and Manual Tests no error codes are showing. However when running the Regular Cycle, the spin cycle would not start up and the machine would go into Rinse again and the lid lock would blink. It would act like it did not know what step to do next. I got a F7 E1 error codes. I replaced the control board and the machine acted the same way. I then replaced the actuator. The washer now runs all the way through the regular cycle but seems to be stuck when it is in the spin cycle. It will spin for 5 minutes straight. I then have to go and cancel it since it will not automatically go to the DONE step. Any thoughts?
Answer Sherri, If you are getting an F7E1 error after replacing the shift actuator then the issue would most likely be caused by a faulty shift actuator because the speed sensor would be part of the actuator. Read More... Answered by AppliancePartsPros.com | Tuesday, August 29, 2017