Melissa for Model Number WTW5700XL2 Machine stopped working mid-cycle leaving clothes wet. After we emptied all the water, the machine would turn on, the lid would not lock, and the timer would count down. There was no noise or humming. Upon doing some research on this site, we purchased the shift actuator, replaced it, and the machine worked for 5 loads, then stopped working mid-cycle and has been doing the same not-working thing since. Please advise. Thank you.
Answer Melissa, The shift actuator seems to be the "weak link" in the system, and can produce several "false" codes and can cause the machine to malfunction and/or stop during the cycle. The second thing to check, is the wire harness between the shift actuator and the main control board in the control panel/console. But, the best thing to do is raise the top panel, or raise the front of the washer and retrieve the tech data sheet in the bag, taped to the inside of the front panel. Then you can program the control, and review the flashing light patterns/diagnostic codes, and operate all the washer components and determine where the issue is and repair the washer quickly and properly. You may want to recheck the actuator and the actuator linkage to make sure the linkage remained attached and didn't slip out after you put the machine back together. Read More... Answered by AppliancePartsPros.com | Tuesday, September 5, 2017