Ken for Model Number Kenmore 11026002010 I moved a Kenmore washer to my address that worked the previous day. After hooking it up, the unit would not start filling up on either cold or hot settings. I have good water pressure to the machine & no obstructions at the water inlet valves. I ran temp AC power to each of the inlet valves & water began to fill. I was told that I either have a bad control board or shift actuator. Can you advise me if there is a way to isolate the problem so I can order the correct part? Thanks.
Answer Hello Ken. Make sure the lid is closed and the unit locks. If not, it will not fill with water. If that is good, then you will need to replace the control board on the unit if the wiring harness is good. Read More... Answered by AppliancePartsPros.com | Friday, March 30, 2018