Scott for Model Number Kenmore 110.21302012 I have gone through several diagnostic tests and have observed that sometimes the shifter actuator will not move from the spin location to the agitate location. Running manual tests I can see it trying to make the switch to the agitate position several times and then it will stop trying. However sometimes it will move from spin to agitate and the test will run fine. Motor runs, etc. I think that tells me the electronics/cables that signal the shifter to switch modes are good but either the shifter motor/gear has a bad spot/is too weak OR the splutch is too hard for the motor to switch positions. I've disassembled the splutch and didn't see any obvious issues and can move the switch ring back and forth manually, gears all look good and engage properly in both settings. I'm going to put some lithium grease on the splutch and if that doesn't work replace the shifter assembly. Does that make sense or am I missing something else?
Answer Scott, based on the information provided, it sounds like the shift actuator WPW10006355 is failing. Read More... Answered by AppliancePartsPros.com | Sunday, July 25, 2021