Gavin for Model Number MVWX500XW2 I have a Maytag Bravo X top load model MVWX500XW2. The washer was stopping short of spin cycle. I replaced the shift actuator and the lid latch. And now it’s not actuating at all. I double checked to make sure the wires are all OK and that the pin and sensors were aligned and everything looks ok. The calibration stops after one minute and I get the red light on the lid lock before anything actuates/moves. Any suggestions on what to specifically check for?
Answer Gavin, thanks for your question. Check the connection and wiring to those components, and then try running the diagnostic test and or the calibration again. Read More... Answered by AppliancePartsPros.com | Monday, May 12, 2025