Bob for Model Number KGRA806PSS02 I am having the same problem as Andy. I remove the 8 screws from the bottom of the panel, but I cannot access the screws behind the end caps. How can I get to those?
Answer Bob, Based on the "R" in your model number, you should have a "free standing" range. This should help " To remove the electronic oven control (EOC) assembly on freestanding models: a) Open the oven door, and remove the screws from the bottom of the control panel .b) Remove the two cooktop trim screws. c) Slide the cooktop trim back to expose the end cap screw, and remove the screws (1 on each side). d) Perform steps 5d, 5e, and 5f to remove the EOC assembly. 5d) Pull out on the bottom of the control panel, unclip the top edge from the bracket, and rotate the control panel forward so you can access the components. e) Disconnect the wire connectors fromthe electronic oven control board at P1 and P2, and the ribbon cable connector at P40. f) Remove the four screws from the electronicoven control housing, and remove the assembly from the control panel. NOTE: The EOC boards and the housing are replaced as an assembly." That ought to get you through the repair. Good Luck and Thanks Read More... Answered by AppliancePartsPros.com | Tuesday, February 21, 2012