Billy for Model Number whirlpool mod. #rs675 pxeb2 After self clean was used the oven refuses to heat, I removed the upper and lower elements and checked for continuity and they checked ok. Any suggestions to try next, thermal overload, heat sensor? It sounds like some thing is clicking like a solenoid, and the latch assembly seems to be working.
Answer Hello Billy, The first place the check is in the breaker box. Flip the breaker off and back on to ensure neither side of it is tripped. The next place to check is the thermal overload WP9759243. If it tests good, the next thing to look at is the oven sensor WP4451665. This should test at about 1100 ohms of resistance at about 70°F. If that tests good, the last suspect other that possible poor electrical connections, would be the microcomputer 4452240 which shows to be no longer available. If this turns out to be the case, you can contact corecentricsolutions.com to see if they support board part number 4452240. Read More... Answered by AppliancePartsPros.com | Wednesday, July 9, 2014