Deb for Model Number JES9900BAB I have just purchased a used Jenn-Air black downdraft electric range (JES9900BAB) with a problem. The oven heats, the thermostat registers the temperature, but the heat doesn't turn off. I believe, from searching, that I need to replace the control board (part 74011576, which I understand is now replaced by W10206067). Am I correct that this is the part I need? Can I make this repair myself? Is it a matter of removing a couple of screws, pulling off the old part and seeding the new one in? Thank you
Answer Hello Deb, You should first check the resistance of the temperature sensor 12001656. This is the part that tells the control board what temperature the bake compartment is. If it is bad, the board will not receive the proper information. The sensor should read about 1100 ohms at about 70°F. Be sure to tap on the sensor while testing it since it is common to have an intermittent problem. If it reads properly, you should then test the sensor from the control board to make sure there is no harness issue. If it reads the same from the control board end of the harness, the control WP8507P234-60 will have to be replaced. Read More... Answered by AppliancePartsPros.com | Friday, April 25, 2014