Bernard for Model Number Jennair JGS9900BDS Hi, The Vent Fan On/Off switch on my range went hay wire. Normally, when I press the vent on/off switch, it will go to on low on first press and then on High upon pressing it a second time. Third press of the same button will switch Fan OFF. Now, when I press it once, the display goes to Warming Drawer in orange ( I don't have a warming drawer in my range) and then option for HIGH or LOW. If I press either high or low, the fan turns into a blower (blowing air IN, instead of exhausting out)! Tried to reset the range. It displayed error code EE-214 M-214. Do I need a new control panel or do I need a new Electronic Control Board? Thanks Bernie
Answer Bernard, You will need to disconnect the ribbon harness from the control and test the harness on pins 5 and 11. You should have a continuity reading when you press the vent fan button. Any reading under 2000 is a passing reading. If the test passes replace the control, if fails replace the console WPW10206071 Ribbon pins are read from left to right. Read More... Answered by AppliancePartsPros.com | Thursday, November 29, 2018