Margaret Counts Samsung Dryer DV350AER/XAA. I replaced the heating element assembly.Went to test machine and do error code came up. So no way to start machine to test for dryer heat. Do I need door catch, door switch, door lever, door sensor. All of the above? You have no Idea? I do know that the do error was not coming up prior to me having the vent professionally cleaned. I also know the dryer was not getting hot. So had vent cleaned, ordered full heating assembly. Went to test. The do Error came up. I checked the wiring on right side of top control panel. Looked good. May not be the wires I should be checking. What do you suggest? I really need my dryer to work. ASAP and cannot afford to hire it done.
Answer Margaret, It would be recommended to check to make sure that the door switch is properly wired, this would be the most common cause for this type of issue. If this checks ok then the door switch may be faulty and if the door switch is good it is possible that the control is not reading door as being closed and would need a board. Read More... Answered by AppliancePartsPros.com | Friday, June 1, 2018