Stan for Model Number Jenn-Air SVD48600B I have a Jenn-Air SVD48600B, the stove top works fine. The oven works when the buttons are pressed, it beeps and gets/stays at the input temperature. However none of the LEDs light up on the display (they did about a year ago). Is the only part that would need to be replaced the Oven Control Assembly - AP4088560? Assuming that is the only part is there assembly instructions for the removal/install? Thanks
Answer Hi Stan. The electronic control is part # WP71001799. Remove the power. Remove the door. Remove the trim screws surrounding the top. This will give access to the front panel upper and lower screws. Then lift up and off the front panel. The clock/control is screwed to the back of the front panel. Take a picture of the original wire lead connections and mark them down so you can reconnect them correctly. Reassemble in reverse steps. Thank You. Read More... Answered by AppliancePartsPros.com | Thursday, December 8, 2011