Customer Questions and Answers for Electronic Control by Whirlpool

Joe, first thing, if you haven't yet, check the inlet valve and fill hose screens for debris and clean them out. At the main control board, disconnect the TH2 connector, with a multimeter, check for approximately 10,000 ohms resistance across the two wires in the connector. If you have the resistance , then replace the control board, anything other than a resistance reading(open or closed circuit) you'd have a bad tub temperature sensoror wiring problem. You are aware that this washer has "target temperatures" and your cold water temperature is going to be approximately 70 dgrs. ?