Customer Questions and Answers for Electronic Control Board by Whirlpool

Hello Greg. WPW10124269 is the clock assembly. 1. Unplug microwave oven or disconnect power. 2. Remove the microwave oven from its mounting location. 3. Remove the eleven T10 Torx screws from the top cover of the microwave. 4. Lift the back of the cover, slide the spring tab out of the control panel slot, and remove the cover. 5. CAUTION: Discharge the high voltage capacitor using a 20,000 O resistor from the terminals to chassis ground. 6. Disconnect the six ribbon cables from the user interface board connectors. 7. Unclip the user interface board from the holder and remove it from the unit. Remove the two T20 Torx screws from the user interface board holder and remove the holder from the subpanel. Remove the four T20 Torx screws (two on each side) from the control panel assembly and remove the assembly from the unit. Place the control panel on a padded work surface. To remove the display, press out on the four holder clips, and pull the display out of the holder. Reinstall in reverse order. Hope this helps.