Arlene for Model Number MDB7100AWB Maytag My dishwasher did not drain at all & I couldn't change any settings yesterday. I turned off the breaker overnight & tried it today. It only did the complete cycle including drain on the 'rinse only' cycle. It will occasionally begin the 'normal' or 'light' wash cycles but either stops right away & makes a couple of sounds or else fills but stops part way through the wash and refuses to drain. When it quits it gives a soft clicking sound and the panel led lights flicker until I use the stop button or cut the power. Only the 'rinse only' cycle works right. Am I correct in thinking the control panel is faulty? The front cover panel it fits behind looks intact. What part number would I need?
Answer Hello Arlene, This actually sounds like you could have a poor electrical connection causing a high current condition, breaking down the circuit and shutting down. Turn off power to the unit and remove the kick panel and the metal box labeled electrical connection and make sure none of the wire nuts have melted. If this checks out ok, open the door panel to access the control board and look for any signs of moisture. If you do find moisture, you will need to replace the seal around the vent. If no moisture, remove and reconnect the wiring to the board, looking inside each for any signs of discoloration. If nothing is found, the control board 12001718 has probably failed. Since the board is no longer available, you will have to do an online search for a company like corecentrics that rebuilds boards for an estimate on rebuilding the board. Read More... Answered by AppliancePartsPros.com | Friday, September 6, 2013