Linda for Model Number MDB7100AWW I have a Maytag mdb7100aww that will run through the cycles and will run then drain at about the 65 minute time, then it fills with new water then kicks off and the clean light and the heated dry light will start blinking... it started out it only did this on the light wash, and the normal and heavy were still working, now it is doing this on all washes.. Can you tell me what part I need to fix this?
Answer Hello Linda. You will need to test the thermostat WP99001852 and the heater WP99001995 and make sure they are good. They should read closed for continuity. If they are good, you will need to replace the PCB assembly WP99002824. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More... Answered by AppliancePartsPros.com | Tuesday, February 14, 2012